Sig Magnum Advice please

well here's a few photo's I hope that they will be helpful

first I extended the mounts (because they were junk )
[photo not recovered: 3ddfda871e947f9c.jpg]
then test fit
[photo not recovered: 3ddfd91e1d5056aa.jpg]
cut and fit crutch balsa
[photo not recovered: 3ddfd94a1d6fe154.jpg]
the small plywood and bolt is for tank mounting
[photo not recovered: 3ddfd7831bca63a6.jpg]
glue together and then put a thin coat of epoxy
[photo not recovered: 3ddfd7d41c1c79ad.jpg]

[photo not recovered: 3ddfd7a61be9c1a8.jpg]

[photo not recovered: 3ddfd7ef1c23c1a8.jpg]

Here's a few shots of this evenings playtime.

here's the front top block, once I finish sanding it then off it comes for hollowing

[photo not recovered: 3deb243d2a055fc3.jpg]

now onto the turtle deck formers and stringers

[photo not recovered: 3deb248d2a536cb8.jpg]

lets skip a few steps and walla a nice straight fuse

[photo not recovered: 3deb24be2a8d003e.jpg]

a couple a body shots

[photo not recovered: 3deb24f82abc54c0.jpg]

a little more sanding

[photo not recovered: 3deb25d12b6f2a99.jpg]

and these are almost ready to be removed for hollowing