Boulder City, NV Flying?

Stuka Stunt Main Forum · 6 of 6 known posts recovered

Chris Brainard · Mar 12, 2004 09:35 AM

I'll be in Boulder City, NV on 3/13 - 3/15 and am wondering if there is any place to fly?

Chris Brainard

Bigiron13 · Jul 21, 2000 03:30 PM

RE: Help discribing C/L carb for Enya#1 source

LAST EDITED ON Jul-21-00 AT 03:32 PM (EST)

VR Joe, I believe I was the one who asked for measurements for the carb. I believe that the dimensions you give here are tha same as on mine. With Dial calipers, the base 0of the carb measures 0.430 wide (13/32 == .4062) the carb measures 0.465 from front to back. (15/32 == .468) The hole through the carb measures 0. 234 inch. So Based on those figures, I believe it will fit. The width dimension is close so check your measurements
Bigiron

Old Sourdough · Jul 21, 2000 06:28 PM

RE: Help discribing C/L carb for Enya#2 source

Joe,

I think that you are looking for the Black Plastic venturi inserts that came with the C/L versions of the square intake versions of the Enya .35, #5224. You will also need the NVA for the engine as well, since the needle valve body from the RC Carburetor will not fit properly in the new insert.

I believe that I may have traded them, but I'll see if I can find the ones I used to have around here.

Jim T. · Jul 21, 2000 10:14 PM

RE: Help discribing C/L carb for Enya#3 source

Sometime back Iskander posted that he simply carved carb inserts out of balsa and soaked them with CyA. Beats carving them out of motormount stock, I would think.

Jim Thomerson

gearhead · Jul 22, 2000 05:47 PM

RE: Its a Done Deal.#4 source

The shop knows all, and thats where its going. Thanks for the input.

V/R Joe Limon

Old Sourdough · Jul 23, 2000 11:12 AM

RE: Help discribing C/L carb for Enya#5 source

Joe,

The part you need is shown in the engine at:

http://cgi.ebay.com/aw-cgi/eBayISAPI.dll?ViewItem&item=385737956

Have fun.