I am building a Cardinal Profile. I just measured the incidence. The motor is 0 degrees. The wing is 0 degrees also. The stab is +1 degree. What should I do?...leave it or maybe move stab down to + 1/2 degree??? What do you think??
CARDINAL PROFILE
Stuka Stunt Main Forum · 5 of 5 known posts recovered
SRiese5283 · Oct 10, 2003 10:48 PM
#1 source
>I am building a Cardinal Profile. I just measured the
>incidence. The motor is 0 degrees. The wing is 0 degrees
>also. The stab is +1 degree. What should I do?...leave it or
>maybe move stab down to + 1/2 degree??? What do you
>think??
>incidence. The motor is 0 degrees. The wing is 0 degrees
>also. The stab is +1 degree. What should I do?...leave it or
>maybe move stab down to + 1/2 degree??? What do you
>think??
Why have any incidence. Wish I could measure 1 degree
Scott(000)Riese
Brett Buck · Oct 10, 2003 11:27 PM
#4 source
>I am building a Cardinal Profile. I just measured the
>incidence. The motor is 0 degrees. The wing is 0 degrees
>also. The stab is +1 degree. What should I do?...leave it or
>maybe move stab down to + 1/2 degree??? What do you
>think??
>incidence. The motor is 0 degrees. The wing is 0 degrees
>also. The stab is +1 degree. What should I do?...leave it or
>maybe move stab down to + 1/2 degree??? What do you
>think??
Move to 0- but make sure that any uncertainty is on the side of the LE being up, instead of down.
I may be doing a disservice by mentioning my incidence experiments - it's not the sort of thing that follows the "stunt flier's maxim", IOW - if a little is good, a lot IS NOT better!
Brett