ST46 muffler

Looking for a T/muffler and mount system to fit an
ST46 with no muffler lugs,any suggestions much appreciated.

I can Make them......
E-Mail Me at [email protected]
This something I don't stock BUT I have to do one for me so an extra is NO problem.

>I can Make them......
>E-Mail Me at [email protected]
>This something I don't stock BUT I have to do one for me so
>an extra is NO problem.

OH PAUL.....That will cost you 1/3rd of the Blazers.......lloollllol

>Looking for a T/muffler and mount system to fit an
>ST46 with no muffler lugs,any suggestions much appreciated.
>

I do have these, also, that fit over the exhaust and bolt on if you have the center tapped hole for this purpose. Then one of our bolt on mufflers with normal ST spacing will fit. If your engine does not have that center hole, oops!

You can also weld an adapter to the csas, or even weld some thick wall aluminum tube to the sides of the case, making sure it is heavy enough to clear the head bolts and take the pressure. You do want to make sure these are lined up straight, however, or you can end up with a tilted muffler.

It's best that you get them from Mr. Neuman because I have to make each one. AS I SAID not in stock.

Thanks for all of your E-MAILS.

Scott( just a guy with an oar)Riese

Paul, I weld lugs on cases with expert quality. Scott Dinger-HYFLO MUFFLERS/Allweld email: [email protected]

""">Paul, I weld lugs on cases with expert quality. Scott
>Dinger-HYFLO MUFFLERS/Allweld email: [email protected] """"

HI Paul
I can attest to the fact that Scott does very high quality welding, I have seen his work and it is first rate, I would take
him up on his offer to put lugs on this motor

A Merco silencer will fit straight on.