Stuka Stunt Control Line Forum
Archive, 2000–2021 · recovered from the Internet Archive
Forums › Stuka Stunt Main Forum

Speaking of fuel tanks and such...

Stuka Stunt Main Forum · 6 of 6 known posts recovered

Ron · Jul 15, 2004 12:32 PM

#0 source
How long does it take to fly the OTS pattern? How much engine run time should I allow for to determine tank size, which will determine how large to make the tank compartment in the fuselage...

I may have to move a bulkhead a little bit to get in a 4oz. tank

Jim T. · Jul 15, 2004 12:37 PM

#1 source
With 40-size engines, I use a 3-oz tank for OTS and a 4 oz tank for modern stunt. However, it is easier put less fuel in a too large tank than more fuel in a too small tank.

Jim

otshodges · Jul 15, 2004 01:14 PM

#2 source
I normally use 3.5 oz tanks in my OTS ships. However, I only put in 3 oz. of fuel. That gives me an average of about 5 min 30 sec of run time. That run time gives me about one minute to spare after I finish the pattern.

Bill Hodges
OTS Rulz!!!

T.Durrill · Jul 15, 2004 01:18 PM

#3 source
otshodges,

What engines are you using in old time stunt which will give enough time on 3 1/2 ounces of fuel?...........T.Durrill

T.Durrill

Bigiron13 · Jul 15, 2004 01:29 PM

#4 source
On my All American Sr and with a Fox stunt 35 or the CS 35, 2 1/2 ounce tank will get me through the OT pattern with no problem. 3 oz will not get you an over run, but you will have a considerable amount of flying around between the last maneuver and the landing.

Bigiron

Bigiron13

SRiese5283 · Jul 15, 2004 03:17 PM

#5 source
I use a 3.5oz for a McCoy 29 in my All American. I get 5.30 mins

Scott Riese