Alignment tolerance

A while back, Brett posted an essay on alignment and acceptable/practical tolerances. Unfortunately, I neglected to archive it. I've searched every combination of key words I can think of and have come up with goose eggs. Does anybody have the link or the text to that post?
Thanks for your help.
Derek Moran

>A while back, Brett posted an essay on alignment and
>acceptable/practical tolerances. Unfortunately, I neglected
>to archive it. I've searched every combination of key words
>I can think of and have come up with goose eggs. Does
>anybody have the link or the text to that post?
>Thanks for your help.
>Derek Moran

I did? You mean this one?:

http://www.clstunt.com/cgi-bin/dcforum/dcboard.cgi?az=read_count&om=6315&forum=DCForumID1

That's the only one that comes very close. If I posted something else relevant, I can't recall it.

No, I found that one last night, and while it’s a great read, it’s not the post I was looking for. The one I remember gave ± parameters for decalage, hinge line parallelism, stab tilt, &c. Ring any bells?
Thanks Brett,
Derek

I know the one you're talking about. Haven't found it either. It was in answer to the question, "How close is close enough, anyway?" Plus or minus a sixteenth here and there, you know...