Forums › Classifieds

Veco kits

Classifieds · 5 of 5 known posts recovered

Dan Mrozek · Oct 11, 2003 10:48 PM

#0 source

Looking for some older Veco or Dumas kits.I have a thing for Veco and Johnson stuff.Please reasonable.Thank you,Dan:+

Phil Hawkins · Oct 11, 2003 11:48 PM

#1 source

Hey Dan,

I might have one of those planes you are looking for already built. I am not sure what ones I have. I know you are getting ready to move, but I lost your email address....
[email protected]

Dan Mrozek · Oct 12, 2003 12:39 PM

#2 source

Hi Phil,keeping them out of the ground? [email protected]

Phil Hawkins · Oct 12, 2003 09:26 PM

#3 source

Well Dan, This morning I flew my Banshee and I think I finally have solved my run issues... It ran beautiful and flew great, a real fun plane to kick around... I switched planes to my new Twister and did not take enough time to reset my handle, while flying inverted I came in too low and just caught the ground, knocking off the rudder and scuffed the paint a little, but it was a clean snap and did not "uglify" my plane. The Banshee shows a few battle scars, but it flys great... I put a 10/7 prop on that Fox on the Twister and got the fuel tank right (I think) and it was flying real smooth until pilot error:( I'll try again next week:) Check your email...

Dan Mrozek · Oct 12, 2003 11:37 PM

#4 source

Phil,use a 10/6 W on that Fox.The W is for wide blade.Rev-up use to make them,sure worked good for me.7 inch pitch is too much for a Fox.Happy landings,Dan.