prop for Ro jett .40

Stuka Stunt Main Forum · 8 of 8 known posts recovered

stephen · Feb 10, 2007 09:41 PM

#0 source

What size carbon prop do I us for a Ro Jett .40 motor. And who sells these props. Thanks

Crist Rigotti · Feb 10, 2007 11:16 PM

#1 source

Have you contacted Richard Oliver? He should know. He goes by Mavrick on this forum.

Crist Rigotti
"A driver trying to be a pilot."
http://www.clguy.com

Steve Helmick · Feb 10, 2007 11:38 PM

#2 source

You got the .40BSRE on a pipe, header muffler, or side exhaust with muffler? If the RE/pipe, Dee Rice recommended an APC (11-4, I think). Mike Haverly was fighting with his piped BSRE/Oriental Plus and Bolly CF's, and the APC was a spectacular improvement. So, I'd also suggest checking with Dee.

Steve

Steve Helmick
Renton, Washington
USA

Mike Haverly · Feb 11, 2007 01:59 AM

#3 source

That's it! APC 11x4, dyed black of course.

Mike Haverly

Mike Haverly · Feb 11, 2007 02:08 AM

#4 source

Whoa! wrong, it's an APC 11 1/2 x 4, wide blade. It made a big difference. Again, make the grey go away.

Mike Haverly

Larry · Feb 11, 2007 11:12 AM

#5 source

My RoJett 40 with the rear header-muffler works best with the Thunder Tiger Cyclone propeller 11-4.5. It is not carbon fiber. www.thundertiger4u.com. Larry Lindburg

Larry Lindburg AMA 95707

Randy Powell · Feb 14, 2007 07:49 PM

#6 source

And those Thunder Tiger props work quite well.

Maverick · Feb 14, 2007 09:24 PM

#7 source

Steve, All of these are good mentioned here. More choices if you like are,
Gator 11x4-3 blade or 11.5x4-2 blabe. Bill Lee 11x4-3 blade or Eather phelps copy 11.25 4.5-2 blade or Bolly 11.8x4.3(I think?) cut down till it works for your set up. If you can find one the Phelps is good but he no longer sells them, 10 3/4x4.5. A little small but works on low nitro. Rev-Up 12x5 or 4 cut down.
I assume you are still running on the pipe and in an Oriental plus?
RO