Does anyone know what might fit this that is already out there manufactured? I got a deal on a RC/ Magnum .25 Gp and could not pass it up.
Don Newman
Small Venturi and Needle Assembly Magnum .25 GP
Classifieds · 3 of 3 known posts recovered
I'm sure Leonard Neumann can send you one that is correct.
I run my FP 25s with a Super tiger style needle valve or use the R/C prinkler as a spigot with a delrin venturi.
Leonard has all the right stuff I think.
Click the Stuka Stunt Works link at the top of this page.
FWIW
Curt
I run my FP 25s with a Super tiger style needle valve or use the R/C prinkler as a spigot with a delrin venturi.
Leonard has all the right stuff I think.
Click the Stuka Stunt Works link at the top of this page.
FWIW
Curt
Curt:
I presume you are referring to the NVA assembly used on the RC carb. Where did you find a 4x0.5 mm tap? Do you find this works better than the usual spraybar assembly?
On my GP 25, I just drilled out the case for a standard OS 25FP venturi and OS spraybar assembly. I found the GP C/L sprinkler venturi to be too big, and hard to seal off fuel leaks.
Jim
I presume you are referring to the NVA assembly used on the RC carb. Where did you find a 4x0.5 mm tap? Do you find this works better than the usual spraybar assembly?
On my GP 25, I just drilled out the case for a standard OS 25FP venturi and OS spraybar assembly. I found the GP C/L sprinkler venturi to be too big, and hard to seal off fuel leaks.
Jim